![]() ![]() ![]() Prerequisite: dynamic disksĪs a basis for mirroring, the hard disk must be converted into a dynamic disk. Mirroring hard disks on Windows is by no means new, Windows has supported it for decades. This variant of course requires a bit more system resources, but is hardware-independent. As an alternative, the mirror can be set up on Windows if a Home version isn't currently in use. In this case, the controller does the work and presents two mirrored disks as one to the operating system. In addition, many motherboard manufacturers offer the possibility to mirror hard disks in the BIOS. Windows includes a solution for mirroring hard disks. To do this, the mirror could be added as described here, and then removed again. ![]() For this reason it would also be conceivable to clone a hard disk via "mirroring". A mirror is something like the permanent cloning of the hard disk, so the constant comparison of both hard disks. In some internet articles mirroring is confused with cloning, see also: hard disk cloning, copying, image tools. This article is also available as Youtube Video. If a hard disk fails, the data is available on the second disk, the computer continues to work and can be started with the setup described here even after the failure. Mirroring the Windows partition is very easy, but not setting up the partitions so that it is possible to boot from the 2nd hard disk in the event of an error. Mainly a hard disk mirroring is used for the protection against the failure of a hard disk. Mirroring is the simultaneous writing to two hard disks, also called Raid 1. ![]()
0 Comments
Leave a Reply. |